- ページ 5

ガレージドアオープナー dtm GO801/1001のPDF 組立マニュアルをオンラインで閲覧またはダウンロードできます。dtm GO801/1001 12 ページ。

ページを印刷する

1. Introduction

1.1General information

Electromechanical drive, designed to automate garage doors. The assembled and launched system

can be conveniently operated by radio transmitters (remote controls).

1.2. Technical dataGO801/1001

power supply:

•

nominal power:

•

maximum gate movement speed:

•

nominal traction force:

•

maximum pulling force:

•

temperature range:

•

built-in lighting, lighting time:

•

total length with head and handle:

•

maximum stroke of the trolley:

•

maximum door width:

•

maximum door area:

•

Ingress ProtectionCode:

•

1.3 Mechanical components

Before starting work, make sure you have all the elements shown in Figure 1, and then read the entire

manual.

2. MECHANICALASSEMBLY

2.1. Verification of the type and structure of the gate

In order to properly complete and install the automation system, verify the type of your gate and check

the structure of the existing or installed gate in terms of the requirements presented below:

The basic set enables the automation of sectional gates with an ordinary running rail - it is recommended

•

to use a "boomerang" type handle, with a double running rail - without a "boomerang", overhead gates -

without a "boomerang" and side gates, fig.2;

The structural elements of the gate must meet the requirements of EN 12604;

•

4xM6

Part definition:

1 drive head with lighting;

2a 1.65m rail with a toothed drive belt;

2b 1.65m rail;

3 coupler;

4 carriage and emergency release locking mechanism;

5 ceiling hanger;

6 pin and securing pin, bolt and tension spring;

7 front piece;

8 tension element;

9 cart-gate pusher;

10 gate hardware;

Fig. 1. Set of mechanical elements.

230-240VAC 50/60Hz

235/245W

180 mm / s

350N/400N

800N / 1000N

-20 °C to + 40 °C

permanent LED, 3min.

3480 mm, 2x1.65m folding rail with toothed belt

2820mm

5000 mm

12.6 m2

IP-20