- ページ 4

はしご Atwood MHL2241のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Atwood MHL2241 8 ページ。 Universal hinged ladder for recreational vehicle

5. Align the holes of a triangular mounting bracket with

the holes on a respective handle section. Place a #10-

24x1-1/2" bolt through each set of holes and fasten each

with a #10-24 nut with nylon lock insert. Tighten the bolt

to 16-18 in-lbs until snug to surface (see Diagram #5).

Be careful not to over-tighten the bolt or tube may be

crushed. Repeat with the other handle section.

6. The ladder as packaged is designed with lower mount

pads that are intended to mount to the rear wall below

the rear wall bend line. With the ladder handles resting

on the roof, it can be determined if the ladder will need to

be modified to align with any backer location(s).

If there is an intended backer location that the ladder

must be shortened in order to align to, place the lower

portion of the ladder on the lower portion of the rear wall

and align the pads with the backer area. Now adjust the

angle of the lower ladder portion to be as near parallel to

the lower rear wall as possible. Place a loose standoff

assembly between the rear wall and the lower ladder

section to maintain proper spacing from the rear wall.

When viewed from the side, the upper ladder rails

should intersect the lower ladder rails.

Measure the distance from the top of the top step on the

lower ladder portion to a point ¾" below where the tubes

intersect. Mark the lower rails at this location. This is

the lower rail measurement.

Subtract the lower rail measurement from 9-5/8". The

difference is the upper rail measurement. Identify the

upper ladder step that is just above the tube intersection

location.

Mark the upper rail measurement distance

from the bottom of this step on onto the upper rail. If the

mark ends up at or above the tube intersection location,

that mark is too short and should be disregarded. A new

mark should be made ¾" above the tube intersection

location.