- ページ 11

コントロールユニット ATX SignalOn N-M 18M0 SeriesのPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。ATX SignalOn N-M 18M0 Series 20 ページ。 Rf passive modules

PLANNING

Planning

Several things need to be considered when planning for the location of the SignalOn Series chassis. Some of these are:

• Chassis should only be installed in restricted access areas (dedicated equipment rooms, equipment closets, etc.) in

accordance with Articles 110-16, 110-17, and 110-18 of the National Electrical Code, ANSI/NFPA 70.

• When using open relay-rack style network bays, spacing between bays and at lineup ends may be required depending

on the quantity and type of coaxial cable entering the bays. When spacing bays 0, 5, or 10 inches, verify that vertical

jumper rings will fit between bays.

• A fully loaded chassis may terminate up to two-hundred cables. Consideration should be given to the number of chassis

installed in a rack to prevent cable congestion.

• Allow sufficient room for cable management behind the chassis. Also leave sufficient vertical and horizontal cable

pathways above and below the chassis.

SignalOn

Series – RF Passive Modules - Installation & Operation Manual

ATX Confidential & Proprietary

CHAPTER 3: PLANNING

3-1