- ページ 4

DJ機材 ABSTRACT ClubRevolutionのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。ABSTRACT ClubRevolution 19 ページ。

Abstract Universal Instruction Manual
5.
Dip switches. Dip switches 1-9 set the DMX channel that the unit will respond
to (in binary code). Channel 1 is the first valid DMX channel. If all switches 1-9
are off, the unit will automatically set its own DMX channel. Switch 10 sets the
stand alone 'group' of the unit, either 1 (off) or 2 (on). See the last page of this
booklet for help on setting the switches.
6.
Microphone. The unit can sense the beat of the music through this built-in
microphone.
7.
Mains power (not shown in picture). Power is supplied to the unit through an
IEC connector on the back face of the unit. There is a power supply fuse built
into this connector. If this fuse fails you should take the unit to an Abstract
dealer for service.
Futurescan 1, Gladiator Revolution and DuoColour have captive power
leads.
8.
Lamp alignment (not shown in picture). "Club" effects only. On the bottom of
the unit (the opposite end from the mirror) there are 3 screws marked "Lamp
align". These allow you to adjust the position of the lamp within the reflector to
optimise the evenness of the light beam.
The alignment is set at the factory and you should not need to change it unless
you renew the lamp.
9.
Focus (not shown in picture). You can focus the light beam for sharp gobo
projection by turning the lens. If you turn the lens anticlockwise several turns,
the lens will come out of the unit allowing it to be cleaned.
On the Twister 4 and Galactic Star, there is a slider knob on the top of the case.
Turn the knob anticlockwise to loosen it, focus by sliding backwards and
forwards, then turn the knob clockwise to lock the focus position.
10.
Remote control socket (Futurescan 1, Gladiator Revolution and
DuoColour). The "remote control" (3 buttons) can be connected to this socket
using a stereo jack cable. Do not connect any other equipment to this socket or
damage may result.
Note: when power is not connected to the unit, the DMX input and
Page 4
output connectors are bridged through by a relay to maintain
the DMX circuit.