- ページ 11

DJ機材 ABSTRACT Gladiator RevolutionのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。ABSTRACT Gladiator Revolution 19 ページ。

Abstract Universal Instruction Manual

Maintenance of the unit

In typical use, the unit will get dirty due to smoke fluid, dust and cigarette

smoke.

Every few weeks you should clean the mirror and lens of the unit using a soft

damp cloth to ensure maximum light output. Do not use abrasive cleaners or

solvents to clean the optics of the unit. Using a vacuum cleaner, remove fluff

from the fan outlet and the air intakes on the unit. If the airflow becomes

restricted or blocked, the unit will overheat. This will shorten the working life of

the unit and may result in the thermal trip activating on Club series units.

If you are operating the unit regularly for prolonged periods (e.g. nightclub

installations) you should take the unit to an Abstract dealer for full servicing and

internal cleaning a few times a year. Do not attempt to open the case yourself as

electrical hazards are present inside, and you risk damaging delicate internal

parts.

To replace the lamp, first turn off the unit, remove the power, and if the unit

has been operating, wait 15 minutes for it to cool down.

Club range units: Remove the lamp by taking out the thumbscrews in the end

plate and withdrawing the lampholder through the rear end of the case.

Remove the old lamp from the lampholder and fit the new lamp.

You must not touch the quartz glass of the lamp! Handle by the

ceramic base only.

Replace the lamp into the unit and refit the thumbscrews. Power up the

unit. Adjust the lamp for best brightness and evenness of light using the 3

screws on the lamp plate.

Futurescan 1, Gladiator Revolution and Duo Colour: Open the hatch on the top

of the unit by removing the thumbscrew. Slide out the old lamp. Pull the

connector off the lamp and plug it onto the new lamp. Refit the lamp.

Close the hatch.

Twister 4 and Galactic Star: Open the hatch on the front of the unit by removing

the two thumbscrews. Slide out the old lamp. Pull the connector off the lamp

and plug it onto the new lamp. Refit the lamp. Close the hatch.

Page 11