- ページ 6

ボート ABSTRACT AB LB7606のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。ABSTRACT AB LB7606 10 ページ。

USE:

1. INFLATION AND MOUNTING

Absolutely do not use a high-pressure compressor. If the board is over pressurised it will suffer irreparable, unguaranteed, damage and could injure

the user.

1 - Unroll the SUP on a flat, clean surface.

2 - Unscrew the valve cap (b).

3 - Raise the centre knob in the valve by turning it 1/4 of a turn counter clockwise (a).

It pops up in a high position.

4 - Insert the tube of the hand pump. The tip fits a 1/4 turn into the valve. 5 - Then inflate your SUP.

6 - Turn the board over and slide the central fin into the slide until it stops.

7 - Insert the locking tab. The fin is mounted.

Do not subject the SUP to prolonged sun exposure that could increase the pressure of your SUP beyond 18 PSI.

Do not hold your face too close to the valve when inflating and deflating. The valve may be damaged and sand or other debris may be ejected.

In case of overexposure to the sun, regularly lower the pressure of your SUP by deflating it.

2. CLEANING, DEFLATIONAND STORAGE

1 - Place the SUP on a clean, flat surface.

2 - Rinse with clean water after each use at sea.

3 - Take out the fin.

4 - Unscrew the valve cap (b).

5 - Press on the centre button in the valve (a) and turn 1/4 of a turn clockwise

until it locks.

6 - The air escapes automatically and the button is at the bottom.

7 - If you wish to stop deflation, press the button and turn it 1/4 of a turn counter

clockwise. Deflation will stop when the button rises.

8 - Dry with a towel or a soft cloth to prevent any (b) mould forming

or deterioration of the fabric and then roll the board starting from

the opposite end to the valve. The air will continue to escape through the valve.

9 - Close the cap (b) of the valve.

10 - Fold the board with the fins facing outwards to ensure the eva pad longevity.

11 - Store the board in a dry place.

WARRANTY :

All our SUPs are guaranteed for 1 year against construction defects.

(a)

(b)

Valve cap

Open and close

button by pressing

and turning 1/4 turn.