- ページ 4

温度コントローラー Auber Instruments WS SeriesのPDF クイックマニュアルをオンラインで閲覧またはダウンロードできます。Auber Instruments WS Series 14 ページ。 Programmable pid temperature controller with dual probe
Auber Instruments WS Series にも：クイックマニュアル (15 ページ), クイックマニュアル (14 ページ), 取扱説明書 (18 ページ), 取扱説明書 (18 ページ)

ページを印刷する

at the back of the controller. The long probe with a bend at the end is for the meat

internal temperature measurement. It needs to be plugged to the bottom sensor jack at

the back of the controller. The tips of the probes are dropped into the damper hole. Place

a piece of tape on the top of the smoker tower to hold them in place. The tip of probe 1

should be placed close to the food but high enough so that it does not touch the food.

(See Figure 3). The tip of probe 2 is to be inserted into the meat.

Figure 3. Sensor position. Left, the sensor should be placed close to the food but high

enough so that it does not touch the food. Right, hold the sensor in place by a piece of

tape.

For the "Original" and Stainless Steel Bradley smoker, the Temperature Heat Control

Switch on the smoker tower should be slid to the Hi position (Most right).

There are several ways to power up the controller and Bradley Smoker.

Figure 3.1 Power Cable wiring for Original Bradley Smoker

Cable A: Power cable for Smoker Tower, C14 plug

Cable B: Power cable for smoke generator, NEMA5-15P plug