- ページ 12

温度コントローラー Auber Instruments WS-1211GPHのPDF クイックマニュアルをオンラインで閲覧またはダウンロードできます。Auber Instruments WS-1211GPH 12 ページ。 Programmable precision pid temperature controller

ページを印刷する

4) Change PrG=on, current b1 recipe is:

C-1=200, F-1=2.0;

C-2=190, F-2=160;

C-3= 130, F-3=30.0.

9. Factory reset function

WARNING! This function will restore all the parameters (including receipts in the memory) back

to factory default. Please write all the necessary settings down. For details on how to access

these parameters, please check section 9 of the main instruction manual.

To reset, under the normal operating mode, press and hold SET key for 2 seconds until LED

display "LoCK", and then release the SET key. The display will show "0" then. Use "+" key to

adjust the number to 666 and press SET key again to confirm. The display will show as "lnlE",

then it will show as "off". Press "+" key once to change "off" to "on". Press SET key to confirm

factory reset. The display will show "----" then "8.8.8.8." When you see this display back to normal

operating mode, factory reset completed.

Please note: In older versions, it may show InIE options as "y" or "n", instead of "on",

"off". To reset, please select "y".

No part of this datasheet shall be copied, reproduced, or transmitted in any way without the prior, written consent

of Auber Instruments. Auber Instruments retains the exclusive rights to all information included in this document.