ヘアードライヤー Conair 124ANPのPDF 取扱説明書＆スタイリング・マニュアルをオンラインで閲覧またはダウンロードできます。Conair 124ANP 2 ページ。 1600 watt compact styler with dual voltage
ページを印刷する
IMPORTANT SAFETY
4. Never operate this appliance if it has a
damaged cord or plug, if it is not working
INSTRUCTIONS
properly, if it has been dropped, damaged,
or dropped into water. Return the appliance
When using electrical appliances, especially when
to a Conair Service Center for examination
children are present, basic safety precautions
and repair.
should always be taken, including the following:
5. Keep the cord away from heated surfaces.
Do not pull, twist, or wrap the cord around
the appliance.
READ ALL INSTRUCTIONS
6. Never block the air openings of the
BEFORE USING
appliance or place it on a soft surface, such
as a bed or couch, where the air openings
KEEP AWAY FROM WATER
may be blocked. Keep the air openings free of
lint, hair, and the like.
DANGER –
Any hair dryer is electrical-
7. Never use while sleeping or drowsy.
ly live even when the switch is off. To reduce
8. Never drop or insert any object into any
the risk of death or injury by electric shock:
opening or hose.
1. Always unplug it immediately after using.
9. Do not use outdoors or operate where aero-
2. Do not use while bathing.
sol (spray) products are being used or where
3. Do not place or store appliance where it can
oxygen is being administered.
fall or be pulled into a tub or sink.
10. Do not use an extension cord with this
4. Do not place in, or drop into, water or other
appliance.
liquids.
11. Do not direct hot air toward eyes or other
5. If an appliance falls into water, unplug it
heat-sensitive areas.
immediately. Do not reach into the water.
12. Attachments may be hot during use.
WARNING –
Allow them to cool before handling.
To reduce the risk of
13. Do not place appliance on any surface
burns, electrocution, fire, or injury to persons:
while it is operating.
1. This appliance should never be left
14. While using the appliance, keep your hair
un attended when plugged in. Do not pull,
away from the air intake openings.
twist, or wrap line cord around dryer.
15. Do not use with a voltage converter.
2. This appliance should not be used by, on,
For a dual voltage hair dryer:
or near children or individuals with certain
16. Be sure dual voltage selector is in correct
disabilities.
voltage position before operating. Before
3. Use this appliance only for its intended
plugging in, read the information about dual
use as described in this manual. Do not
voltage contained in the instruction section of
use attachments not recommended by the
this manual.
manufacturer.
17. This appliance was set at the factory
to operate at 125 volts. Refer to Additional
the arrow points at 125. In this position, the
Information section of this manual for conver-
dryer operates on all available heat and speed
sion to 250 volt operation.
settings.
SAVE THESE
INSTRUCTIONS
Fig. 1
OPERATING
FOR 220–250 VOLT OPERATION
INSTRUCTIONS
First put the speed switch to Low and the
heat switch to Hot. Turn the dual voltage
switch to the 250 position. At 220–250V while
This appliance is intended for household use
the speed switch is set at Low and the heat
only. Use on Alternating Current (50/60 hertz)
switch is set to Hot, the dryer operates only at
only. Standard dryers are designed to operate
high speed with high heat. Do not attempt to
at 110 to 125 volts AC or 220 to 250 volts AC.
operate/change the setting on the speed and
This appliance has a polarized plug (one blade
heat switches or change to 125 position when
is wider than the other). As a safety feature,
operating on 220–250V. The switches must be
this plug will fit in a polarized outlet only one
set and remain in the Low (on speed switch),
way. If the plug does not fit fully in the outlet,
Hot (on heat switch) and 250 positions. A plug
reverse the plug. If it still does not fit, contact a
adapter may be necessary in certain countries.
qualified electrician. Do not attempt to defeat
IMPORTANT
this safety feature.
FOR DUAL VOLTAGE DRYERS
CHECK ALCI SAFETY FEATURE
For use in the U.S.A., the voltage selector
EVERY TIME YOU USE DRYER
switch should be placed in the 125 position.
This hair dryer is equipped with an Appliance
For use in several countries overseas, the volt-
Leakage Circuit Interrupter (ALCI), a safety
age selector may need to be placed in the 250
feature that renders it inoperable under some
position. Confirm the voltage available at each
ab normal conditions, such as immersion in water.
overseas location before using the appliance.
For connection to a 250 volt supply, use an
To make sure the ALCI is functioning properly,
attachment plug adapter of the proper configu-
perform the following test. The purpose of this
ration for the power supply receptacle.
test is to allow you to make sure the ex clusive
water sensing system (ALCI) is working.
FOR 110–125 VOLT OPERATION
Confirm that the dual voltage switch is set to
1. Plug in the appliance and press test button
125 (see Fig. 1). If it is not, then use a small
on plug.
coin or a paperclip to turn the switch so that
2. The appliance will stop working. There will be
dry hair to remove excess moisture. Section
an audible click and reset button will pop out.
hair. Using the dryer along with your styling
brush, direct hot air through a section of hair
This indicates the ALCI is functioning properly.
at a time. Move dryer steadily across each
3. To reset ALCI, unit should be unplugged.
section so that the hot air passes through hair.
Then push reset button in, and reinsert plug
Direct airflow at hair, not scalp.
into outlet.
2. Keep dryer's air intake vents unobstructed
Reset
and free from hair while drying.
Test
3. To avoid over-drying, do not concentrate
heat on any one section for any length of time.
Keep dryer moving as you style.
4. For quick touch-ups between shampoos,
4. If ALCI is not functioning properly, return
dampen hair with a mist of water before styling
hair dryer to an authorized Conair Service
with the dryer.
Center.
BODY & VOLUME
5. It is important that if immersion occurs, this
To create extra volume,
unit be brought to a service center. Do not try
turn head upside down
to reset.
while drying. Position the
6. Be sure to repeat test every time you use
airflow toward the roots for
the unit to confirm ALCI is operational.
maximum lift. When hair is
Should the appliance go off and the reset
dry, toss head back and
button pop up during use, this could indicate
brush hair into place.
a malfunction in the unit. Remove plug from
STRAIGHTENING
outlet and allow the appliance to cool. Reinsert
Work with hair in sections
plug into outlet.
when creating a super-
The appliance should then function normally.
straight look. Using a large
If not, return to an authorized Conair Service
round brush (approximately 2"
Center for evaluation and repair.
in diameter), hold hair taut in
SUPER STYLING GUIDE
each section and bend ends
Your best looks begin with a good haircut that's
slightly under as you dry.
well maintained. Always treat hair right with
MAKING WAVES
superior quality shampoos, conditioners, and
Tousled, natural-looking
finishing products.
waves are easily created by
grasping hair at the roots
DRYING BASICS
and scrunching between
1. Shampoo and condition hair with the prod-
fingertips while drying.
ucts of your choice. Rinse thoroughly. Towel-
The Conair
1600 Watt Compact Styler – the
GET TO KNOW YOUR DRYER
®
ultimate travel companion. Equipped with
dual voltage for worldwide travel.
1600 watts
FEATURES
1.Power
1600 watts of drying power.
2. 2 Heats/2 Speeds
for styling versatility.
3. Folding Handle
for easy storage.
4. Dual Voltage
for worldwide travel.
Folding handle
2 heats/speeds
Dual voltage