- ページ 2

メディア・コンバーター 3onedata 3012-5VDCのPDF クイック・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。3onedata 3012-5VDC 3 ページ。 Gigabit ethernet media converter

ページを印刷する

Model III

Gigabit Ethernet fiber port

Power supply indicator PWR

Gigabit Ethernet fiber port indicator (FX / FX ACT)

Ethernet copper port 100M speed indicator (100M)

10M/100M/Gigabit Ethernet copper port indicator

(TP-TX / TP Link)

Ethernet copper port duplex indicator (DUP)

Ethernet copper port Gigabit speed indicator

(1000M)

10M/100M/Gigabit Ethernet copper port

5VDC Terminal block for power input

10.

Wall Mounting lug

11.

220VAC/DC power input outlet and switch

12.

Terminal block of -48VDC power supply input

13.

Reserved

【Mounting Dimension】

Unit: mm

 Model I

 Model II

Model III

Note Before Mounting:

Don't place or install the device in area near water or



moist, keep the relative humidity of the device

surrounding between 5%~95% without condensation.

Before power on, first confirm the supported power



supply specification to avoid over-voltage damaging the

device.

The device surface temperature is high after running;



please don't directly contact to avoid scalding.

【Wall-mounted Device Mounting】

Step 1

Place the device on the wall as reference or

reference installation dimension; mark 2 bolt

positions on the wall.

Step 2

Hang the device on the labeled wall; align the bolt

to the labeled position, then screw the bolt to

enhance stability, installation ends.

【Wall-mounted Device Disassembling】

Step 1

Device power off.

Step 2

Hold the equipment steady and unscrew the screw

on the wall

Step 3

Take out the device, disassembling ends.

Note before powering on:

Power ON operation: First insert the power supply



terminal block into the device power supply interface,

and then plug the power supply plug contact and power

on.

Power OFF operation: First, remove the power plug,



and then remove the wiring section of terminal block.

Please pay attention to the above operation sequence.

【Power Supply Connection】

 5VDC power supply

Model I provides 1 DC round head for power supply

input and support 5VDC power supply.

 220VAC/DC power supply

Model II provides 1 AC outlet with switch for

power supply input and support 220VAC/DC

power supply.

 -48VDC power supply

Model III provides 3 5.08mm pitch terminal

block for power input, supports -48DC power

supply. The pin definition as follows:

-48VDC+

definition

【Checking LED Indicator】

The device provides LED indicators to monitor the device

working status with a comprehensive simplified

troubleshooting; the function of each LED is described in the

table as below:

LED

Indicate

Description

PWR

running normally

-48VDC-

connected

and