- ページ 6

マッサージ Conair BTS4C SeriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Conair BTS4C Series 10 ページ。 Dual jet bath spa cordless
Conair BTS4C Series にも：取扱説明書 (4 ページ)

SAVE THESE INSTRUCTIONS

FOR HOUSEHOLD USE ONLY

OPERATING INSTRUCTIONS

This charger has a polarized plug (one blade is wider than the other). As a safety feature,

this plug will fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse

the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety fea-

ture.

CAUTIONS

• This unit should not be used in the following cases unless directed by physician: Tuberculosis,

benign and malignant tumors, hemorrhages, inflammations of the skin, phlebitis and thrombosis,

open and fresh wounds, bruises, broken skin or varicose veins, or undetermined calf pain.

• Consult your physician if you have any therapeutic questions regarding spa use.

• Do not use on any unexplained pain before consulting your physician.

• Discontinue use of unit if pain increases or swelling occurs after application.

• Do not use on any part of the body that is anesthetized.

• Do not use on any part of the body where recent surgery has been performed.

HOW TO CHARGE THE BATH SPA

Note: your bath spa is shipped with the batteries partially charged. Before initial use, charge the bath

spa batteries for 2-3 hours.

After the initial charge, your bath spa will require about one hour to fully charge. When bath spa is

fully charged, the charge indicator will no longer be illuminated.

TO CHARGE

1. Unit should be clean and dry. Turn switch to the off position.

2. Place bath spa on a flat, dry surface away from water.

3. Raise the folding arm and lift up the rubber seal to expose charging jack.

4. Connect the charge adapter plug to the charging jack.

5. Plug charging transformer power pack into a 120V/60h/z standard electrical outlet.

6. The charge indicator (beneath mood light lens) will illuminate to show that the unit is properly

charging. When bath spa is fully charged, the charge indicator will no longer be illuminated.

7. After unit has charged (for at least 1 hour), disconnect charge transformer power pack from electri-

cal outlet and then disconnect charge jack from unit. Reseat rubber seal by pressing rubber seal

firmly into the charge jack opening.

8. To secure unit to bath tub, follow How To Use instructions.