- ページ 4
コードレス電話 Conairphone SW2514のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Conairphone SW2514 8 ページ。 Classic wallphone with caller id
HANGING THE PHONE ON THE WALL
Place the handset in the base cradle when the SW2514 is wall mounted.
On a wall phone plate
1. Plug the short telephone line cord
into the jack in the base bottom
and into the jack on the plate.
2. Hang the base on to the two pins
and pull the base down to lock it
on.
3. Plug the coil cord into the handset
and base jacks.
On a wall without a plate
1. Install 2 screws with anchors into
the wall, one above the other.
3-1/4" apart, extending 3/16" out
from the wall to hold the base
securely.
2. Install the long telephone line cord
into the jack in the base, thread it
through the groove and plug it into
the modular wall jack as shown.
3. Hang the base on the screws and
pull it down to lock it into position.
4. Plug the coil cord into the handset
and base jacks.
TELEPHONE FEATURES
Tone/Pulse Switch
Set switch to your type of service. If you don't know whether you have tone
or pulse:
1. Put the switch on "T" (Tone)
2. When you have a dial tone, press any key on the keypad. If the dial tone
stops, leave it on "T" (Tone). If not, change the setting to "P" (Pulse).
Receiver Volume Control
The receiver volume control is located on the side of your base unit. This
enables you to adjust the receiver volume from normal to high for a better
listening level.
7
Ringer On/Off
Your SW2514 features a mechanical bell ringer. When you don't want to be
disturbed, slide the switch to the OFF position. You can still make outgoing
calls without being disturbed by incoming calls.
Pause
Whether you have Tone or Pulse service you can insert a 4-second PAUSE
into the dialing or storing of a number into memory in order to access
custom and telebanking services, long distance, etc. Press [REDIAL] at the
desired point in the number. Press [REDIAL] again if an additional 4
seconds is needed.
Redial Button
Automatically redials last number called (up to 32 digits). If the number was
busy or unanswered:
1. Lift the HANDSET.
2. Press [REDIAL].
TELEPHONE OPERATION
NOTE: Only basic phone operations (dialing out using the handset and
receiving calls using the handset) will operate without the batteries.
Receiving a Call
1. When your phone rings, pick up the handset and use it like any basic
telephone.
2. Hang up the handset to release the telephone line when your
conversation is completed.
Dialing a Call
1. Pick up the phone and wait for a dial tone.
2. Press the keypad for the telephone number you wish to dial.
Tone/Pulse Combination Dialing
Combination dialing is useful to subscribers of Pulse (rotary)
service who wish to gain access to various low-cost long-distance or
automated computer services otherwise not available to them.
1. With the TONE/PULSE switch in the PULSE position, dial the phone
number.
2. Press [*], and your telephone will change to TONE dialing mode.
3. Dial your code/authorization number. When your call is completed, your
telephone will automatically return to the PULSE dialing mode.
NOTE: Combination dialing can also be stored into the memory for
one-touch access to your long distance or automated computer service.
8