ヘアードライヤー DAN DRYER Elite Classic 2000のPDF インストールと使用説明書をオンラインで閲覧またはダウンロードできます。DAN DRYER Elite Classic 2000 2 ページ。

INSTALLATION & USER INSTRUCTIONS

DAN DRYER

ELITE 2000 HAIR DRYER

Enclosed with the hair dryer are the installation instructions as well as a small

plastic bag containing:

2 pcs. screws

2 pcs. rawlplugs

2 pcs. washers

1 pcs. plastic cap

1 pcs. wall mounting bracket

PRIOR TO INSTALLATION:

Before installing the hair dryer, please check that the power supply has

sufficient capacity to handle the extra wattage specified on top of the dryer

housing.

Be sure to install the unit right next to a mirror, if any, thus preventing users

from stretching the flexible hose to the breaking point in the attempt to look at

themselves in the mirror.

The hair dryer is double-insulated and thus needs no earth connection.

FIXED WALL MOUNTING:

➊

Disassemble cover plate by removing the in Fig. 1 with A marked screw.

Attach unit to the wall, using the two holes marked with screws and

rawlplugs.

➋

Mark and drill two 6 mm holes in the wall, vertically underneath each other

and 198 mm apart (Fig. 2). Recommended installation height from the floor

to the top edge of the dryer is 180 cm.

➌

Feed supply cable through the cable inlet hole at the top right corner and

connect to terminal block. Attach dryer housing using the screws and

washers enclosed (Fig. 3).

IMPORTANT



Reassemble cover plate before test running the hair dryer.



Fixed installation must be carried out by a qualified electrician.

The ELITE hair dryer complies with the EU directive 87/308 on the reduction of

electromagnetic interference.