- ページ 5

コントローラー Concens C4-MKIIのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Concens C4-MKII 9 ページ。 Actuator controller for up to 4 actuators

Tips

It is recommended to follow the tips below to achieve the best results and avoid problems in daily operation.

General

Always wait at least two seconds after the last actuator has stopped before removing the battery from the

controller. Otherwise controllers using position feedback may not have time to store the position, and the controller

will have to be 0-point calibrated again.

If the battery's safety thermostat is activated due to overload, the battery must be allowed to cool for at least half

an hour before being used again. A new battery may be inserted into the controller after one minute.

If two or more actuators which operate in parallel become misaligned, the controller will automatically shut them

down. It will then be necessary to perform 0-point calibration again as described in section 5.

Batteries

Always use batteries which are in good condition and fully charged when inserted into the controller.

You can extend the lifetime of the battery by occasionally recharging it even though it is not fully discharged.

If the battery level drops below the critical level and the system shuts down, you must wait at least one minute

before inserting a different battery and using the system again.

If the system is not to be used for an extended period (several days or weeks), the battery should be removed from

the controller to avoid deep discharge, which can cause lasting damage to it.

Handling

Avoid getting metal shavings or other magnetic objects on the battery poles or in the controller.

If problems or irregularities arise you should go through the points below (in consultation with a technician where

appropriate).

Check that all connectors are correctly attached to the controller.

Check that the controller sounds a beep when the battery is inserted.

If the actuators cannot be operated, perform a 0-point calibration as explained in section 5.

If none of the above resolves the problem, please contact the supplier.

C4-M K I I v6 62

U S E R M A N U A L

January 2022