- ページ 2
フィットネス機器 concept 2 SkiErgのPDF 組み立てと設置をオンラインで閲覧またはダウンロードできます。concept 2 SkiErg 2 ページ。
ページを印刷する
Floor Stand Assembly and SkiErg Installation
5
Remove the two pre-installed fasteners from
lower portion of the SkiErg. You will reinstall
these in the next step.
7
Assemble four fasteners and washers and insert
through each of the four holes in the SkiErg
bottom bracket and into the wooden base (two
holes on each side). Tighten all fasteners.
(4) 1 1/4" fasteners
PN 2206
(4) black washers
PN 1259
9
Loosely attach the U-bar bracket the SkiErg using
four fasteners. Once all four fasteners are in
place, tighten fully.
(4) 1/2" fasteners
PN 1231
6
Carefully place the SkiErg on the wooden base
so that it lines up with the four inner holes on
the universal bracket. Reinsert the two fasteners
removed in step 3, and two additional fasteners,
through the universal bracket and into the SkiErg.
(2) 1/2" fasteners
PN 1231
8
Using a fastener and washer, attach the U-bar
to the wooden base on each side. Tighten until
fully seated.
(2) 1 1/4" fasteners
PN 2206
(2) black washers
PN 1259
Page 2
0815
CONCEPT2.COM