- ページ 3
スピーカー Elite Acoustics Engineering A2-5のPDF クイック・マニュアル・ハンドブックをオンラインで閲覧またはダウンロードできます。Elite Acoustics Engineering A2-5 5 ページ。 Acoustic amplifier with 4 channels, mixer, effects, battery powered and bluetooth
Elite Acoustics Engineering A2-5 にも： マニュアル (11 ページ)
ページを印刷する
Channel 2
Gain [30]: Apply gain for level control
Mute [31]: Mute Channel
EFX/AUX Send Level [32]: Adjust the level to "send" out
EFX/AUX select [33]: select internal EFX or external AUX bus
PAD [34]: fixed attenuation for "hot" signals
Line [35]: 1/4" TS inputs
Mic In [36]: XLR for Microphone Input
Channel 3/4
Level [37]: Set the gain for both channels 3 & 4
EFX Send Level [38]: Adjust the level to "send" out
Left (Mono) [39]: 1/4" mono TR input
Right [40]: 1/4" mono TR input
Monitor Right Output: [41] Connect to another speaker using 1/4" TS
Foot Switch: [42] TR footswitch to control Effects Bypass remotely
Aux
AUX Send [43]: 1/4" TR output
AUX Return [44]: 1/4" TR input
Main Outputs / Chan 1/2 Direct Output: [45] Select source of XLRs as Main mix or Direct
Outputs for Chan 1 & 2
Output Level: [46] Set output level for XLRs
Left [47]: XLR Left Output
Right [48]: XLR Right Output
Battery Switch[49] : Built in Circuit Breaker to preserve battery life.
Connect: Enable battery power when using unit
Disconnect: Disable battery power when storing unit to preserve battery life
Refer to reference page for features listed above
•
To turn ON/OFF Bluetooth® function
PRESS/HOLD down MODE button for approximately 5 seconds
•
To pair device to the speaker system
Bluetooth® needs to be turned ON
QUICK TAP the MODE button once
If the battery is low and the audio is intermittent or choppy, the battery should be recharged.
1.
Put power switch in the "OFF" position and Battery Switch in the Connect position
2.
Plug in power adaptor into the DC input jack
3.
Blue "Charge" LED will turn on, indicating the speaker is charging
4.
When the speaker is fully charged, the blue "Charge" LED will turn off. Allow up to 20
hours to fully recharge
BLUETOOTH® FUNCTION
Both LEDs will flash at the same time
Both Flashing LED: indicate Bluetooth
Flashing Blue LED only: indicate Bluetooth
TO FULLY CHARGE SPEAKER SYSTEM
•
Recharge after every use
•
Use & recharge battery at least once a month
•
DO NOT leave power switch in the "ON" position when it is not in
use. Doing so after a long period of time will damage the battery
•
Keep unit in a cool, dry place away from extreme temperatures
•
Do not service, modify, or replace the battery
•
If the battery fails to charge, contact Elite Acoustics Engineering
FOR MAXIMUM BATTERY LIFE
is ready to be paired
®
is connected
®