- ページ 9

送信機 ADDER AdderLink X-SeriesのPDF マニュアルをオンラインで閲覧またはダウンロードできます。ADDER AdderLink X-Series 15 ページ。 Usb extender
ADDER AdderLink X-Series にも：マニュアル (18 ページ)

ページを印刷する

Special configuration

In operation, the Dual Video Transmitter is generally an unseen and transparent

element in the system. Most of the configurable options and usability settings

(such as passwords, hotkey controls, etc.) are made at the receiver units, where

the keyboards, video monitors and mice are connected. There are, however, two

important configuration options particular to the Dual Video Transmitter, both of

which are controlled by switch 1 on its side panel.

Password override

This mode allows you to override any passwords that have been set at the

remote receiver(s) and place them into configuration mode so that new ones

may be set. This feature is particularly useful when passwords have been lost or

forgotten.

To override remote receiver passwords

1 Power down both remote receivers.

Note: If you wish to leave one of the receivers unchanged, leave it switched

off during this process – do not power the unit while the configuration

switch on the Dual Video Transmitter is set.

2 With power to the Dual Video Transmitter still on, change switch 1 to the

ON position.

3 Power on one or both of the remote receivers. The powered on receiver(s)

will go directly into configuration mode so that new passwords may be set

(without requiring the old one(s). For details about setting passwords, please

refer to the user guide for the X-Series Extenders.

4 Once the remote receiver(s) have entered configuration mode, return switch

1 of the Dual Video Transmitter back to its OFF position. Note: If switch 1

remains ON, then the Dual Video Transmitter will enter upgrade mode when

it is repowered and will not operate normally.

Flash upgrade

As part of the continual development and improvement process across the range

of Adder products, software upgrades are occasionally made available. The Dual

Video Transmitter's internal flash memory and Adder's unique keyboard-link

upgrade technique allow you to utilise software upgrades in a straightforward

manner.

Note: X-Series receiver modules can also be flash upgraded. For further details,

please refer to the user guide for the X-Series Extenders.

To perform a flash memory upgrade, you need to perform the following stages:

• Stage A – Download upgrade files from the Adder website

• Stage B – Create a startup diskette and copy the files to it

• Stage C – Reconfigure the connections and begin

• Stage D - Return the connections to their usual state

Stage A - Download the upgrade files

To download the files

1 Access the Adder Technology Ltd website (www.adder.com), enter

the Support section. Choose the upgrade option that best suits your

requirements and download it to your system.

2 Decompress the downloaded file. Depending on the chosen option, there

will be a collection of suitable files. As a minimum, there should be the

following files:

• AUTOEXEC.BAT – directs the computer to run the upgrade programs.

• XKVMxxx.EXE – this is the upgrade program that causes upgrade data to

be sent to the Dual Video Transmitter from the computer.

• XDVTxxx.HEX – this is the firmware file for the Dual Video Transmitter.

Where xxx is the upgrade version number.

Now please follow Stage B.