- ページ 2

カードリーダー ADDER Secure AS-4CRのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。ADDER Secure AS-4CR 5 ページ。 Smart card reader

Introduction

WELCOME

Thank you for choosing an ADDER™ Secure product. This smart card reader allows the

use of one smart card to logon to four computers simultaneously.

The smart card reader uses a holographic tamper-

evident label to provide visual indications in case of an

enclosure intrusion attempt. When opening product

packaging inspect the tampering evident label. If for

any reason it is missing, appears disrupted, or looks

different than the example shown here, please call

Technical Support and avoid using that product.

CONNECTIONS

The smart card reader operates independently from any computer switches used -

such as the ADDERView Secure switch range. The card reader connects to your host

computers using four USB leads. Connections can be made while the computers are

switched on or off.

To connect the smart card reader

1 Connect each of the four USB (Type-A)

plugs to a vacant USB socket on each

host computer. The four leads are each

1m in length, so the computers will need

to be near to each other and close to the

operator. Standard USB lead extenders

could be used, if necessary. The cable

numbers correspond to the numbered

card reader buttons.

Connect the four USB cables

to vacant USB ports on each

computer

DRAFT

S E

R E

2 Connect the output from the supplied power

adapter to the socket on the card reader

rear panel.

3 Plug the supplied power supply into a nearby

main socket.

Note: As power is applied, there will be a one

second beep sound and the indicators for all

connected channels will flash repeatedly.

From

power

adapter