- ページ 5

セントラル・バキューム・システム AirVac AV2500のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。AirVac AV2500 6 ページ。 Airvac av2500; av5500 central vacuum system

Assembling the Deluxe Electric System

1. Snap the two interlocking wands

together.

2. Push cord plug up as far as it will go

into plug holder, then press into plug

holder until firmly seated.

3. Press cord into clip.

4. Push downward until wand lock button

snaps into place.

5. Insert SUPERHOSE handle into

wands.

6. Plug electric brush cord into hose

handle.

WARNING

ELECTRICAL SHOCK HAZARD

Do not plug into electrical supply until

assembly is complete. Failure to do so

could result in electrical shock or injury.

Troubleshooting

1. No Power:

Check circuit breaker on unit and house power panel breaker to see if they have

tripped. If they have tripped, then reset. If they trip again, call your local M & S

Systems distributor for service.

2. Low Suction:

Check suction at utility inlet on the power unit.

Check for blockage in hose.

Check for blockage in pipe by using a plumber's snake to free any obstruction.

Check for air leaks at inlet valves not in use. A missing or damaged gasket

could cause air leaks.

Check the 2.75" flock filter located in the screen below the motor plate behind

the filter. If blocked or clogged, this can cause low suction.

If you encounter any problems with your equipment, verify the operation against

the information contained in this booklet. If, after checking your system you are

unable to determine the cause of the problem, contact your local dealer for

assistance or our technical support department at (800) 366-9422. Be sure to

have the exact model number, serial number and the nature of the problem

ready. If possible, CALL FROM THE SITE. We cannot effectively troubleshoot

your system if you are not calling from the location where the equipment is

installed or used.