ページを印刷するINTRODUCTION
Scope
This manual provides installation and operation information for the
CONCOA Gas Mizer.
Use
The Mizer is an accessory for inside bench production and assembly line
gas welding and heating operations. It is designed for use in the oxygen
and fuel gas supply, low pressure line of a hand welding torch. When a
hand torch is hung on the Mizer's hanger rod, oxygen and fuel gas are shut
off.
Pilot light burner tips are not included with the Mizer, but are required
for an installation. Order them separately for MAPP
lene, or natural gas.
Description
The inlet side of the Gas Mizer is equipped with a fuel gas pilot light. The
inlet and outlet nipples are B size, RH for oxygen and LH for fuel gas. The
Mizer's shut off valves can be individually adjusted by their seat adjust-
ment screws. This seat adjustment controls ignition by: LEAD for ON
and LAG for OFF.
INSTALLATION
Install pressure regulators on cylinders (or pipline branch). Comply with
CONCOA manual Safe Practices in Welding & Cutting, ADE 872, and
torch and regulator instruction manuals
a. Secure the Gas Mizer on a bench or other horizontal surface, using
four mounting holes. Position the Mizer so that when the torch is
hung on the hanger, torch tip will point away from operator and
in a safe direction.
b. Connect the fuel gas hose to the inlet marked FUEL GAS and the
oxygen hose to the other inlet. Refer to the above table for hose
andfitting accessories. Turn off pilot light adjusting valve (clock-
wise).
c. Connect torch hoses to respective Mizer outlets.
d. Screw pilot light burner (for fuel gas to be used) into Mizer needle
valve securely so that is does not leak.
SAFTEY
gas, propane, acety-
®
3