- ページ 5

産業機器 Concoa 632 SeriesのPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。Concoa 632 Series 17 ページ。 Gas distribution system

INSTALLING INLET AND OUTLET CONNECTIONS

Use an open-end wrench, not a pipe wrench, to install accessories to the system. The NPT connections require the

use of PTFE tape on the threads to make a gas tight seal. On stainless steel connections, the PTFE tape helps prevent

the connections from galling together when tightening or loosening. Follow these rules when using PTFE tape.

Taping procedure:

Figure 1 - Pictorial view of tape seal installation

Before applying PTFE tape, inspect the NPT threads and if necessary, clean the fitting to remove any dirt or thread

sealant that remains on the threads. Start the PTFE tape on the second thread as shown above; make sure the tape

does not overlap the end of the fitting. As the tape is wrapped in the direction of the thread spiral, pull tightly on the

end of tape so that the tape conforms to the threads. Apply two overlapping layers of PTFE tape. Cut off the excess

tape and press the end firmly into the threads.

WALL MOUNTING

632 Installation with Single Hose

1. Determine and mark the vertical center line for installation of the base 63 System.

. Measure from the floor 73" and make a mark on the line of center. Using a level, draw a horizontal line from

the mark extending approximately 10 inches to the left and right of center. The height of 73" is recommended;

Figure 2 - Wall mount installation

CENTERLINE

FLOOR LINE

-5-

73" (1.85 m)