- ページ 11

医療機器 ABTECH SAFETY SLIX Spinal SplintのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。ABTECH SAFETY SLIX Spinal Splint 20 ページ。

Loading and Securing a casualty into the

Slix100 Stretcher

The Slix Stretcher is stored and transported in a Carry Bag.

Remove the Slix Stretcher from the Carry

Bag,

undo the securing strap and

unroll.

It is

recommended that the Slix Spinal Splint is used even if no spinal injuries are present or

suspected.

Refer to Page 10 for identification.

Lay on a flat surface, with the Carry Handles down, as close to the casualty as

possible.

The head of the Stretcher should be level with the head of the casualty.

Place the Slix Spinal Splint on the Slix Stretcher and attach it to the Spinal

Splint Plate with the two fitted straps provided Item 100SSA p10. Place the casualty

on the Stretcher with the head located to the top of the Spinal Splint and centrally

positioned.

If the casualty was loaded onto the Spinal Splint away from the Stretcher, move the

casualty carefully into the Stretcher and attach the Spinal Splint to the Stretcher

Fit the Foot Loops, Item 100FL p10, to the casualties feet, (do not remove

footwear), crossing them over, and adjust

buckles.

If leg injuries are present it may

be necessary to omit one or both Foot Loops

Starting at the foot secure the 4 Closure Straps, Item 100MCS p10, across the

Stretcher and tighten securely but be careful not to over tighten. Pay particular

attention to the Closure Straps at the chest so respiration is not impaired.

Secure the ends of the Closure Straps so they do not present a snag

hazard.

Tucking ends in is easiest

It is recommended that the casualties' arms are inside the Stretcher skin, as shown

on p12

Repeat for the Foot Closure Straps, Item 100FCS p10, and adjust until the rollover

just touches the casualties'

feet.

Allowance should be made if a leg splint is fitted.

The casualty is now secure and evacuation may

begin.