- ページ 13

ラジオ AnyTone AT-500MのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AnyTone AT-500M 13 ページ。 10 meter radio

WARNING

This device complies with Part 15 of the FCC Rules. Operation is subject

to the following two conditions: (1) this device does not cause any harmful

interference; and (2) this radio must accept any interference that may

cause undesired operations.

Note: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

— Reorient or relocate the receiving antenna.

— Increase the separation between the equipment and receiver.

— Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

— Consult the dealer or an experienced radio/TV technician for help.

Licensing Information

Use our radio in USA is subject to the rules & regulations of FCC. Changes or

modifications not expressly approved by our may void the user authority granted by

the FCC to operate this radio and should not be made. To comply with FCC

requirements, transmitter adjustments should be made only by or under the

supervision of a person certified as technically qualified to perform transmitter

maintenance and repairs in the private land mobile and fixed services as certified by

an organization representative of the user of those services. Replacement of any

transmitter component (crystal, semiconductor, etc) not authorized by the FCC

equipment authorization for this radio could violate FCC rules.

Note: Use of this radio outside the country where it was intended to be distributed is

subject to government regulations and may be prohibited.

Important: Any changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate this device. Your

radio is set up to transmit a regulated signal on an assigned frequency. It is against

the law to alter or adjust the settings inside the radio to exceed those limitations. Any

adjustments to your radio must be made by qualified technicians.

WARNING: MODIFICATION OF THIS DEVICE TO RECEIVE CELLULAR RADIOTELEPHONE

SERVICE SIGNALS IS PROHIBITED UNDER FCC RULES AND FEDERAL LAW.

AT-500M