- ページ 10

ラジオ AnyTone AT-5555 PLUSのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AnyTone AT-5555 PLUS 17 ページ。 10 meter radio

ページを印刷する

channel. You can receive the calling, and also, can transmit on this

channel by pressing PTT key. If there is no transmission or detected

signal on that channel within 5 seconds(time to resume scanning can

be programmed by PC software), radio will start scanning again. To

exit the SCAN function, press the SCAN key or the PTT key.

The Scan Type above is the SQ mode under SCA Selection in

Function Menu. If TI mode is selected and valid signal is detected, the

radio would still start scanning when it is time to resume scanning,

whether there is signal or not in current channel.

(2)FUNC+SCAN

SC.LIST (Scan ADD or Delete). Press FUNC+SCAN to delete current

channel from scan list. The first digit on LCD would display. When

Scan function is enabled, the radio would skip the deleted channel.

Repeat this operation to Add or Delete channels from scan list.

20. +10KHZ or HI-CUT

(1)+10KHZ Press this key to shift frequency up by 10khz.

When pressing this key, 10KHZ would appear on LCD and frequency

of channels is shifted up by 10 KHZ. Repeat this operation to switch

ON/OFF this function.

(2)FUNC+ +10KHZ

Press FUNC+10KHZ to realize HI-CUT function. Once this function is

enabled, the radio would cut out high frequency interference. Its use

depends on reception conditions.

When this function is enabled, "HI-CUT" would appear on LCD. Repeat

this operation to switch ON/OFF the function

21. SWR OR TOT

(1)SWR

When pressing this key, "SWR" icon would appear on the LCD. When

transmitting, SRF bars indicate SWR value other than PA or PWR

value. One bar displaying on the LCD indicates that SWR value is

1.0. Each additional bar indicates every 0.1 added value. Repeat this

operation to switch ON/OFF the function.

(2)FUNC+ SWR

When pressing this key, TOT ON or TOT OFF would display on the

LCD for 2 seconds. Repeat this operation to switch ON/OFF the

function. When ON appears on the LCD, users can press PTT to

transmit. Then, the radio would time the transmitting duration. Once

the duration is beyond the set TOT time (programmable), the radio

would emit voice prompt and stop transmitting and back to receiving

state automatically. This function aims to protect the radio against

power tube damage from superheating caused by long transmission.

22. EMG OR S/RF

(1)EMG realizes Emergency Channel Call. When emergent situation

happens, the radio would switch to the channel set in advance to

communicate immediately. Then the "EMG" icon would display on the

LCD . Press EMG key again to return to previous channel.

(2)FUNC + S/RF

S/RF is the switch of TX's or RX's S/RS indicating bar. When this

function is enabled, "SRF"icon would display on the LCD. Repeat the

this operation to switch ON/OFF the function.

23. POWER

Accept13.8V DC power cable with built-in fuse (10 Amp) to be

connected.