- ページ 10

ケーブルとコネクター DuctSox OvalSoxのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。DuctSox OvalSox 12 ページ。

™

OvalSox

Cable

DuctSox

Installation Manual

Step 5

Start Up AHU. Turn on the AHU and inflate the DuctSox System. Check all Gliders and sections to ensure system is inflating

properly. If required, move Gliders to eliminate puckering at binding locations. If lengths do not fit properly, double check all

field measurements and compare to drawings. If all measurements are correct, contact your DuctSox factory rep to discuss

options.

Once system is properly adjusted, inflate the system, pull the last Glider in each straight section (including straight sections

between fittings), and secure tension using Track Stop Screws. Also, be sure to install a Track Stop Screw into the U-Track at

the Endcap Glider, at the Inlet Glider, and at each Glider immediately adjacent to all fittings.

The Track Stop Screw is used to keep sections of DuctSox from moving lengthwise in the U-track. They also are used to put a

slight tension on straight sections of DuctSox (straight sections may consist of more than one zippered section of DuctSox).

The screw is tightened into the bottom channel to lock the stop at locations where Gliders are to be locked in place.

If the system includes elbows or T's, secure Gliders before and after these fittings. Failure to install DuctSox Systems correctly

may void warranty.

Step 6

Air Balancing. System must be balanced to design CFM and static pressure immediately after installation. Most DuctSox

Systems include a zipper at the inlet location for easy access to monitor flow.

If the fabric is fluttering after balancing, please contact your factory rep immediately. Solutions to the fluttering include

adjusting the Adjustable Flow Device (AFD), adding AFDs, or other solutions that would result in a less turbulent airflow.

Laundering Instructions

Sedona-Xm, TufTex, Verona, DuraTex, Microbe-X, Rx, and Stat-X fabrics:

• Remove the DuctSox fabric from your system, being sure to unzip all sections. Take care in recording where each section

was installed.

• Turn soiled side out, soak in cold water for 30 minutes.

• Wash cold, gentle cycle.

• Rinse thoroughly (repeat cycle if water/DuctSox still soiled).

• Drip dry or no-heat tumble dry.

Publication: AMEN00416 2021-02-22