ページを印刷するINSTRUCTIONS FOR THE INSTALLER
Fastening the top
Every cook-top is equipped with a special washer
having an adhesive side.
- Remove the racks and burners from the top.
- Turn the appliance upside down and lay the
adhesive washer S along the external border of
the glass (fig.5).
- Introduce and place the cook-top in the hole made
n i
h t
e
p
e i
c
e
f o
u f
n r
screws of the fastening hooks C (fig.6).
Installation room
This appliance is not provided with a device for
exhausting the products of combustion.
Regarding room ventilation rules where appliance
is installed make reference to the legislation, in
conformity with the local regulations.
Gas connection
Make sure that the appliance is adjusted for
the gas type available (see the label under the
appliance). Follow the instructions indicated in the
chapter "gas transformations and adjustments"
for the possible adaptation to different gases. The
appliance must be connected to the gas system
by means of stiff metal pipes or flexible steel pipes
having continuous walls, in compliance with the
regulations in force.
Gas enters the appliance through a cylindrical
threaded male gas union (1/2").
The connection must not stress the gas ramp.
Once the installation is over, check the connection
seal with a soapy solution.
t i
r u
, e
h t
e
n
b
o l
k c
t i
i w
Electric connection
The appliances does not require to be connected
to the mains power supply as it is provided with a
low voltage ignition generator supplied by a 1,5V
battery.
h t
h t
e
5
8
6