- ページ 12

ホブ DUDOFF GD-Z02のPDF 設置および使用説明書をオンラインで閲覧またはダウンロードできます。DUDOFF GD-Z02 17 ページ。 Built-in gas hob domino

Always disconnect the appliance from the

electricity main before making any adjustments.

All seals must be replaced by the technician at

the end of any adjustments or regulations.

Our burners do not require primary air

adjustment.

9) TAPS

"Reduced rate" adjustment

Switch on the burner and turn the relative knob to

the "Reduced rate" position (small flame fig. 1).

- Remove knob "M" (fig. 13 and 13/A) of the tap,

which is simply pressed on to its rod. The by-pass

for minimal rate regulation can be: beside the tap

(fig. 13) or inside the shaft. In any case, to access

to regulation, it can be done trought the insertion of

a small screwdriver ''D'' beside the tap (fig. 13) or in

the hole ''C'' inside the shaft of the tap

(fig 13/A). Turn the throttle screw to the right or left

until the burner flame has been adequately

regulated to the "Reduced rate" position.

The flame should not be too low: the lowest small

flame should be continuous and steady. Re-assemble

the several components.

ADJUSTMENTS

TAPS LUBRIFICATION

Should a tap being blocked, do not

force and ask for Technical

FIG. 13

It is understood that only burners operating with

Natural should be subjected to the above

mentioned adjustments. The screw must be fully

locked when the burners operate with Liquid

Petroleum (LPG) gas.

WARNING:

To adjust the minimum "DUAL" burner first

remove the bushing "E" (fig. 13).

In the case of a "DUAL" burner, the

regulation screw situated inside the post of

the valve regulates the central flame, while

the screw next to the valve regulates the

outer flame.

Assistance.

FIG. 13/A