バーコードリーダー 2connect M930ZのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。2connect M930Z 2 ページ。
ページを印刷する
10.Scan mode
Trigger Scan
Continuous Scan
Auto Sense Mode
11.Terminator Suffix
Add suffix
No Terminator suffix
Set Terminator Suffix to 0x0D 0x0A(CR+LF)
Set Terminator Suffix to 0x0D(CR)
12、Troubleshooting
problems
Possible reason
Solution
Serial
number
Ensure the scanner is
No power to scanner
Powered On
Interface cable is
1
installed correctly,
but scanner not
started.
Incorrect connection of
Ensure all cable connections
interface cable.
are secure
The Bar code type is
Enable that bar code type
disabled.
Scan a test bar code of the
Damaged barcode
same bar code type
Interface cable
2
connected but
Scanner not
Distance between scanner
Move scanner closer to or
decoding bar
and bar code is incorrect
code
further from bar code
Point the reader at the target
The scanner is not high
and pull the trigger to enable
enough to cover the
the illuminator (red beam) to
barcode completely
decode the bar code label.
Convert input method to
Input method error
standard English input
method
Scanned data
3
incorrectly
Restore the parameters of the
displayed on host
Other settings were made
scanner to the factory settings
for the scanner
state, or contact the vendor
，
service center
Scanned data
Select appropriate country and
Region improperly
4
incorrectly
language encoding scheme
configured
displayed on host
，
Turn off the device power,
connect the device and the
scanner correctly. Restore the
Device conversion error
5
Other faults
parameters of the scanner to
the factory settings state,
rescan the code
Quick Start Guide
Dear users, thank you for choosing our products. we will provide you
with quality products and caring services.
V2.1