- ページ 4

バスルーム設備 Anzzi CS-CTRCS00WHのPDF インストール＆オペレーションマニュアルをオンラインで閲覧またはダウンロードできます。Anzzi CS-CTRCS00WH 4 ページ。 Console sink

Section 1

1.Connect front legs (A) and front crossbar (B).

2.Line up bolt holes where legs and crossbar connect.

3.Install the bolts but do not tighten them at this time.

Section 3

1.Place the stand upright in the desired location and

level using the height adjusters built into the bottom

of the legs.

2.Use a pencil and the pre-drilled holes at the end of

the support bars to mark location of mounting

hardware on wall.

3.Drill holes for mounting hardware in the wall.

4.Insert anchors into the holes and secure the stand

to the wall with the screws.

NOTE: Silicone adhesive and tools necessary for installation are NOT included.

drilling holes

Φ1/4"(6mm)

Section 2

Top leveler

Leg leveler

1.Connect the support bars (C) to the front legs (A).

2.Line up bolt holes where legs and support bars co-

nnect.

3.Install the bolts and tighten all bolts for all parts at

this time.

Section 4

1.Apply a thin coat of silicone adhesive to the back of

the sink where it meets the wall.

2.Apply a thin coat of silicone adhesive to the stand's

top frame where the sink will rest.

3.Carefully place the sink on the top frame of the

stand and center it.

4.Allow silicone adhesive to dry for 24 hours.