- ページ 9

計測機器 Abtus ABT4650 RouteScanのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Abtus ABT4650 RouteScan 17 ページ。

can be added by selecting 'More'. Hide the keypad and select 'Start

Recording'

When ready, select 'Start' to begin the scanning process. The Laser

Housing unit will begin to rotate and after a short period

measurement data will begin to appear on the display. The scan is

automatically broken up into sections. Scanned data is displayed on

the Control Unit after each section has been scanned. By clicking

'Cancel' it is possible to stop the scan at any time; the scan will stop

after it has completed the current section

When the scan is complete, the laser will switch off and the Laser

Housing will rotate back to its Zero position

The profile can now be saved or re-measured – to insert additional

points click 'Single Point'. Position the laser (see Section 4.4) and

click 'Measure'. See below for more information on this step

Single Point

1. Select 'Start Recording' from the 'Options' screen (Figure 1)

2. Select 'Single Point' from the next menu (Figure 6)

3. Control the laser as described in section

4. Click 'Measure' – select 'Save Point' to confirm the measurement – a note

can now be added against this point

5. After adding a note, hide the keypad and click 'Save Point' again.

Note – it is not possible to send commands, other than 'Cancel', from the

Control Unit when the Laser Housing is rotating. Ensure that the Laser

Housing is stationary before clicking any other buttons or closing a

window.

4650-1 Issue 04