- ページ 13

ウォーターヒーター Anzzi ENVO WH-AZ011-M2のPDF インストール＆オペレーションマニュアルをオンラインで閲覧またはダウンロードできます。Anzzi ENVO WH-AZ011-M2 16 ページ。 Electric instant water heater

INSTALLATION

Nipple

Electrical Connections

●

1.Turn the power off at the fuse or circuit.

2. Connect the cable to the breaker.

Install L1 (red wire) to L1, L2 (black wire) to

L2, and E (green-yellow wire) to Ground.

Make sure that the metal wire ends and the

breaker are well connected. Then tighten

the screws to secure the wires.

See ELECTRICAL DIAGRAM on PG.3 for reference.

ATTENTION

1.Make sure that the breaker is switched OFF before installing the wires

to avoid any danger of electric shock. All mounting and plumbing must

be completed before proceeding with electrical connection.

2.The heater must be connected to its own independent electrical circuit.

Install a fuse box or switch ("breaker") for exclusive use of the heater.

3.All unit must be connected to a properly grounded dedicated branch

circuit with proper voltage rating.

1. Open the shut-off valve to allow water to flow

into the water heater.

2. Check for any leaks at plumbing connections.

If there is any leaks from the nipples, hand

tighten them then tighten with wrench. DO NOT

over tighten.

3. Open several hot water fixtures to allow

water to run through the water heater to purge

air from the water lines. Failure to purge air

Fig 7

from the water lines can cause permanent

damage to the heating elements.

4. Check again for any leaks at plumbing

connections. Correct any that are found.

Circuit Breaker

BLACK

RED

GREEN-YELLOW

PG.9