- ページ 11
フォークリフト Cascade 90FXのPDF インストール手順をオンラインで閲覧またはダウンロードできます。Cascade 90FX 14 ページ。 Swing frame paper roll clamp
ページを印刷するI
NSTALLATION
7
Connect hoses prepared in Step 3
to truck supply terminals.
Install stop block kit
8
•
Assure that clamp is centered on carriage.
•
Preheat each stop block and carriage bar weld
area to 325° F (180° C).
•
Weld a stop block on each end of top carriage
bar as shown. Use AWS E7018 low hydrogen
rod and weld a 1/4 in. (6 mm) fillet around each
stop block.
Upper
Mounting Hook
Truck Upper
Carriage Bar
6028021 Rev. 1
1/16 in.
(1.6 mm)
Back (Driver's) View
RC0910.ill
9
Purge air from hydraulic system
IMPORTANT: All functions must be cycled to
remove air trapped in the attachment hydraulic
system before the unit will function properly.
Follow the procedure below:
•
Cycle long arm several times.
•
Rotate to 45 degrees and cycle short arm
several times.
•
Rotate clockwise (CW) or clockwise (CCW)
several revolutions.
•
Cycle swing frame several times while clamp is
in vertical roll-handling position.
•
Cycle swing frame several times while clamp is
in bilge position.
NOTE: If attachment shifts to swing at any time
during the above procedure, actuate the CLAMP
lever and resume rotating until air is fully purged.
Steel Stop
Block
(each end)
RC0937.ill
RC0928 .ill
9