- ページ 4

浄水器 3P Technik 1000515のPDF 操作および組み立て説明書をオンラインで閲覧またはダウンロードできます。3P Technik 1000515 4 ページ。 Rainwater filter for installation into tanks or in the ground

Installation of the 3P Volume Filter VF1 with the 3P Telescopic Extension:

• Lift the lid off the 3P Volume Filter VF1 and lock the lower part of the 3P Telescopic Extension

tube, using the bayonet socket fitting, onto the 3P Volume Filter VF1. It has to be fully engaged.

• The upper surface of the upper ring collarto the upper section of the Telescopic Tube can be

fitted flush at ground level. This leaves the Volume Filter VF1 lid just proud of the groundsurface

for easy removal and access.

• Push the upper section of the 3P Telescopic Extension on to the lower part until you reach the

required height.

• If the final required height is lower than the minimum with the two pieces, simply cut by sawing

the upper or the lower part with a fret saw to the required height.

• If the final required height is higher than the maximum you can use a second

telescopic extension on top.

• Next, back fill the tube surround with gravel or stone chippings. Compress the back fill below

the upper collar of the upper extension section, so that the collars take the loading, and not the

3P Volume Filter VF1 below.

• If installed in a block built inspection chamber there may be no need for the

3P Telescopic Extension Tube, or it can be fittedto the base of an inspection chamber floor.

Maintenance advice:

The filter requires cleaning regularly. If it is not raining unscrew the lid of thehousing and clean with a

water jet the tray and the filter element. Then remove the filter element. Using a 3 mm Allen key undo

the screwsretaining the filter mesh. Rinse the filter mesh with water. Clean with milddetergent and a

stiff brush, both sides to help dissolve any fatty deposits orhydrocarbon build up. Rinse it again. Do not

use a metal brush which maydamage the filter mesh. You may also put the filter mesh into a dishwasher.

After cleaning examine the filter by holding up against the light and inspectfor any blocked holes in the

filter mesh. If the filter is clean put the filter meshback and re-fix in position.

Recommended Accessories:

3P Removal Handle

Ideal for removal of the 3P Filters

from deeper installations.

Remains in position, length: 500 mm

Item No. 1000550

Öschstraße 14

73072 Donzdorf - Germany

T +49 (0) 71 62 - 94 60 7-0

F +49 (0) 71 62 - 94 60 7-99

www.3ptechnik.com

3P Telescopic Extension

Guarantee:

3P Technik Filtersysteme GmbH offers this product

the guarantee required by law (from date of purchase).

Plastic telescopic shaft for

installation directly into the

ground.

Material: Polyethylene

Item No. 1000560