- ページ 10

アンプ Addictive audio F300.1のPDF オーナーズ＆インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Addictive audio F300.1 15 ページ。 Fleck series amplifiers

Adjustment of input level is accomplished by the gain control. Adjusting

this control allows the amplifier gain to be controlled to match the source

unit.

9. 2CH/4CH Signal Pass-Through Selection Switch

For F300.4 set 2CH/4CH switch to "2CH" when running two separate

RCA/AUX cables. When running a single RCA/AUX cable set 2CH/4CH

switch to "4CH" to allow signal to pass through to all channels.

10. MODE

LPF: Set the MODE SWITCH to the LPF position when the amplifier is used to drive a

FULL: Set the MODE SWITCH to the FULL position when the amplifier is used to drive full-

11. High Pass Filter

This controls the high pass crossover point for the speaker outputs. This

crossover, when selected, will attenuate the frequencies below the

crossover point with a slope of -12dB per octave The crossover point is

adjustable from 25-250Hz. This filter reduces unwanted lower frequencies

from being played through the speaker(s).

1. Disconnect the negative battery post and secure it to something so

accidental re-connection does not occur during the installation process.

2. Run all wires needed for the amplifier to work correctly. Do not attach the

fuse in the fuse holder by the battery until all wires have been plugged into

the amplifier.

3. Turn the amplifiers gain and boost all the way down (counter clockwise).

4. As a good "starting point" set phase to 0, subsonic and other adjustment

knobs all the way down (counter clockwise) and mode switches to the

correct MODE being used.

5. Attach the recommended fuse

the main battery.

subwoofer system. The frequencies above the crossover point will be attenuated

at -12dB/octave. Adjust the crossover frequency by rotating the LPF knob to the

desired frequency ranging from 50-150Hz. See #5 below for more details.

range speakers and/or components that come with their own crossover. The full

frequency bandwidth will be output to the speakers without high or low frequency

attenuation.

(refer to fuse chart on pg.4)

to the fuse holder by