- ページ 3

浄水器 3P Technik 1000654のPDF 操作説明をオンラインで閲覧またはダウンロードできます。3P Technik 1000654 4 ページ。 Rainwater filter for bigger roof areas

Installation in the pilot shaft:

Standard concrete shafts with a diameter of Ø 1000 mm can be used. The openings for the

supply and drain lines should be made using a core drill. In doing so, please observe the

following points:

1. Determine the diameters of the supply and drain lines

and select the appropriate drill or core bits.

2. Place the filter into the shaft and connect using short

pipe sections rockers through the concrete walls.

The connections can then be later quickly and easily

made on the construction site.

3. Seal off the openings in the concrete shaft either with

seals (Forsheda or Densio) or wall foam.

4. When installing the pipes, pay attention to the height

differences and position of the connections,

see table on the left side below

When inserting the shaft in the ground, compress the soil well and install the shaft in horizontal

position. Compress the soil underneath the pipes well. No ground settlement must occur in order

to keep the filter housing free from tension. The cascade inserts must be easy to remove and

re-install. This ensures perfect functioning.

350

510 mm

assembly of a Twin Filter

468 mm

521 mm

680 mm

Twin Filter trafficable

Rainwater supply

Draining of dirty

water into the

sewerage system

optionally DN 100 or DN 150

on one side or both sides possible

assembly of a

Rainwater supply

Draining

of cleaned

water into the

reservoir