- ページ 18
カッター Dancutter DC SUPER FLEXのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Dancutter DC SUPER FLEX 20 ページ。
ページを印刷する
14.0 Installation of centring
tool set w/brushes
The hollow/recess on the individual half-globes in the centring
tool set, must ALWAYS face towards the air motor. Were the
spotfacings are tapped into the Half-Globes. This is especially
Installation of centring tool set
Position the spotfacings facing forwards.
18
important for the unit mounted at the rotation point (8.4), as
it would otherwise tighten and prevent the smooth rotation of
the air motor.
The centring kit must be tightened so
that the increase on the trailing edge
of the individual places on the cutter is
continued up the individual blocks.
When operating in the downpipes, mount
the supplied brushes into the holes on
the individual blocks in the centring tool
set.