- ページ 6

オーブン Duke 59 SeriesのPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。Duke 59 Series 20 ページ。 Ovens with “zp” control panel
Duke 59 Series にも：オーナーズマニュアル (20 ページ)

ページを印刷する

Installation and Operation of 5/9 Electric Convection Oven

INSTALLATION INSTRUCTIONS - continued

D. ELECTRICAL CONNECTIONS

The oven is supplied for connection to a 208 or 240 volt

grounded circuit. The electric motor, indicator lights and

control circuits are connected internally and require no

secondary power supply.

Before making any connections to these units, check

the specification plate to assure that the voltage

and phase of the oven is compatible with the

electrical supply. When installing, all ovens must be

electrically grounded in accordance with local codes

or in the absence of local codes, with the National

Electrical Code, ANSI/NFPA 70 (in Canada – CSA Std.

C22.1). Wiring diagrams are located in the control

compartment area. Standard wiring schematics are

also included at the back of this manual.

TOTAL KW

8.0 KW

POWER SUPPLY CONNECTION

120001

Block, Terminal 4 Pole

GROUND WIRES

L 1

L 2

153213

SOURCE

L 3

Plug,

WIRES

Ground

L1, L2 & L3 (3PHASE)

L1 & L2 (1PHASE)

The proper method of connecting the power source

to the terminal block is shown below.

removal of the Control Panel. This is done by

loosening the three screws located at the bottom

of the door opening and remove lower trim piece.

Then remove the screw at the top of the control

panel and then the control panel will hinge forward.

SPECIFICATIONS

VOLTAGE

208

240

222790

Contactor, 240V 50/60Hz

Note to Electrical Inspector:

Inspection of electrical connection

should be accomplished by the

AMPS-1PHASE

AMPS-3PHASE