- ページ 12

アンプ 3rd Power DS 3 '59 ACのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。3rd Power DS 3 '59 AC 17 ページ。 Dream solo series 112 combo amplifiers & heads

Back Panel:

Speaker Outputs (C)

The 16-OHM SPEAKER OUTPUT is provided for connecting your amplifier to

standard 16 OHM speaker cabinet.

The 8-OHM SPEAKER OUTPUT is provided for connecting your amplifier to

single 8-OHM speaker, such as the internal speaker for the combo unit.

The 4-OHM DISCREET SPEAKER OUTPUTs are provided for connecting

your amplifier to single 4-OHM speaker cabinet.

SAFETY NOTES:

• Never operate your amplifier without a connected speaker cabinet. This

will damage your tubes or transformers - or both.

• Always operate your amplifier with the proper impedance output that

matches your speaker cabinets(s).

• In all cases, always use a good quality heavy gauge speaker cable (not a

shielded instrument cable) to connect your DREAM SOLO to the

speaker cabinet.

HybridMASTER™ (D)

The HYBRID MASTER control allows you to set the overall volume level of the

amplifier independent of the volume and tone settings established on the front

panel. This is a patent-pending circuit design developed by 3rd Power and is

available exclusively on Dream and Dream Solo series amplifiers.

Effects Insert (E)

The EFFECTS INSERT of the DREAM SOLO is designed to allow you to in-

sert an effects device (most often, time-based effects like delay or reverb) after the

preamp and before the power amp. When no effects device is present, this circuit

is completely bypassed to deliver a direct signal path between the preamp and

power amp stage.