- ページ 9
対流式オーブン Duke 59-E3LのPDF インストレーション、オペレーション、パーツ＆メンテナンスマニュアルをオンラインで閲覧またはダウンロードできます。Duke 59-E3L 20 ページ。 Electric half-size convection oven little caesars
ページを印刷するA. PROGRAM PARAMETERS
This unit comes pre-programmed from the factory
with the following parameters for Menu items S1
and S2
Menu Item S1
Crazy Bread
# Trays
1
Cook Time
6:00 6:00 6:00
Temperature 375° 375° 375°
On Time
60
Duty Cycle
160
Offset
0
Rack Position
2
NOTE: Rack position is based on counting
from the top rung downward.
B. PROGRAMMING INSTRUCTIONS
To adjust a parameter: cook time, load control settings,
duty cycle time- based, setpoint, offset, the following
process needs to be followed:
a. Select the desired menu item by holding down the
MENU push button and pressing the UP/DOWN
buttons until the menu item is displayed (The
Menu items are numbered S1 through S7)
b. Select the desired menu item by holding down the
MENU push button and pressing the UP/DOWN
buttons until the menu item is displayed (The
Menu items are numbered S1 through S7)
c. Press one of the following buttons:
Switch
1
Cooking Time
2
Cooking Temperature (Setpoint)
3
Duty Cycle On-Time
4
Duty Cycle Time Base
5
Offset
CHANGING OVEN PARAMETERS
2
3
4
6:00
6:00
375°
375°
80
130
160
160
160
160
0
0
0
1,3 1,2,3 1,2,3,4 1,2,3,4,5
To Change
Button 1 Pressed:
The display will show the number "2".
1. Press the button that is to have its baking time
changed. The baking time for the particular switch
will be shown in the display. A baking time must
be programmed for selections 1, 2, 3 and 4. Use
the UP/DOWN buttons to change the baking time
5
to that desired.
NOTE: To change seconds hold in the start
switch for one tray, then use the UP/DOWN
switches.
2. Press the "Enter" switch to store the change.
160
Button 2 Pressed:
The setpoint temperature will be shown in the display.
160
1. Use the UP/DOWN switch to set the new setpoint.
0
2. Press the "ENTER" switch to store the new setpoint.
Button 3 Pressed:
The display will show the number "2".
1. Press the switch that is to have its load control
changed. The load control "ON TIME" for that
particular switch will be shown on the display.
An "On Time" must be programmed for selections
1,2, 3 and 4.
2. Use the UP/DOWN switches to change the load
control setting.
3. Press the "ENTER" switch to store the new load
control setting.
Button 4 Pressed:
The Time Base will show in the display.
NOTE: The Time Base should never be
changed unless directed to do so by
Corporate headquarters
1. Use the UP/DOWN switch to change the Time
Base.
2. Press the "ENTER" switch to store the new Time
Base.
Button 5 Pressed:
The Offset will show in the display
1. Use the UP/DOWN switches to change the Offset
value.
Electric Half-Size
Convection Oven Manual
9