- ページ 6

冷蔵庫 Duke RUF-48 MのPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。Duke RUF-48 M 12 ページ。 48” refrigerated counter digital with 1/3 size food pan insert
Duke RUF-48 M にも：設置および操作マニュアル (8 ページ)

ページを印刷する

Installation and Operation of: Product Name

INSTALLATION - Location

Units represented in this manual are intended for indoor use only. Be sure the location chosen has a ﬂoor or

counter strong enough to support the total weight of the units. Reinforce the ﬂoor or counter if necessary

to provide for maximum loading. For the most efficient operation, be sure to provide good air circulation

inside and out. These units should be located so that they can be moved for service. Major service to the

refrigeration system is done from the rear of the cabinet.

INSTALLATION – Inside Unit

Take care not to block air ﬂow to the fans and allow space along the front, back and sides.

INSTALLATION – Outside Unit

Be sure that the unit has access to ample air; avoid hot corners and locations near stoves and ovens.

CAUTION:

This unit exhausts air to the bottom and the back. Do not seal the unit to the wall or set unit on a curb. The

ventilation slots in the kickplate must remain open.

INSTALLATION – Leveling

Be sure that the units are placed on a ﬁrm, ﬂat surface/ﬂoor. Check for cracks in ﬂooring or tile and avoid

these areas if possible. If necessary place support pads, properly rated for the weight of the unit, to "bridge"

uneven or cracked ﬂooring. Level unit accordingly.

INSTALLATION – Stabilizing

Make sure the unit is installed on a flat surface to insure that the unit is solid to the ﬂoor at all four contact

points. Insure that the unit does not "rock" when pressure is applied to the top corners.

INSTALLATION – Electrical Wiring

The RUF 48 is available as a 120VAC, 60 Hz or as 230VAC, 50 Hz dependent on model. All electrical

connections should be performed by a certiﬁed electrician and should comply with local electrical codes for

your municipality.

REFER TO THE AMPERAGE DATA LIST IN THE SPECIFICATIONS OR THE SERIAL TAG DATA AND YOUR

LOCAL CODE OR THE NATIONAL ELECTRICAL CODE TO BE SURE UNIT IS CONNECTED TO THE PROPER

POWER SOURCE. A PROTECTED CIRCUIT OF THE CORRECT VOLTAGE AND AMPERAGE MUST BE RUN

FOR CONNECTION OF THE SUPPLY CORD OR PERMANENT CONNECTION TO THE UNIT. THE POWER

MUST BE TURNED OFF AND DISCONNECTED WHENEVER PERFORM¬ING MAINTENANCE OR REPAIR

FUNCTIONS.