- ページ 5

掃除機 Dultmeier Sales DU V450WO-9RのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Dultmeier Sales DU V450WO-9R 7 ページ。 Vacuum tank unit

ページを印刷する

Parts Identification

1 - Primary Shutoff - When the tank (2) gets full of

waste, the primary trap (1) will shut off vacuum flow.

1A - Access Lid - Access port to primary trap for

maintenance and tank inspection.

2A - Tank Drain - Drain waste from tank. To assist in

drainage follow these steps:

1. Remove safety cap (2B)

2. Hook up discharge hose

3. Open tank drain (2A)

4. Set pump vacuum/pressure changeover

valve (5B) to neutral (center) position.

5. Allow tank to drain

6. For quicker off loading start motor and turn

vacuum/psi changeover valve (5B) on pump

to #1 - pressure

3 - Secondary Shutoff - When the tank (2) is full of

waste and the primary shutoff (1) fails the secondary

shutoff will begin to fill. STOP USE IMMEDIATELY.

Drain tank (2) and secondary shutoff (3A), then

service primary shutoff (1).

3A - Waste Drain - Use to drain secondary shutoff (3).

4 - Oil Trap Muffler - Catches used oil and reduces

exhaust noise. It is recommended that the oil trap

muffler is drained (4A) at the same time the waste

tank (2) is drained. Properly collect, contain, and

dispose of used oil.

4A - Oil Drain - Use to drain oil trap muffler (4).

5 - Vacuum Pump - It is vital to the longevity of the

pump to read and understand the pump manual.

Always maintain proper oil levels and

IMPORTANT

run pump at proper RPM.

5A - Oil dipstick for Lubrication Oil Tank - Check

and fill oil daily and each time the unit is being used.

Always use vacuum pump oil. See List

IMPORTANT

of Recommended Oils in pump manual.

5B - Vacuum/Pressure Changeover Valve - Switches

from #2 Vacuum to #1 Pressure or neutral (in

between).

5C - Oiler Adjustment - Adjust oiler to 1 drip every

other second. See Lubrication Checking in pump

manual.

6 - Vacuum Relief Valve - Vacuum relief valve will

open when vacuum in tank (2) exceeds 25 HG. This is

factory set during testing and should not need further

adjustment.

6A - Pressure Relief Valve - Pressure relief valve will

exhaust pressure above 5 psi in tank (2).

6B - Vacuum/Pressure Gauge - Use to read vacuum

or pressure of unit.

7 - Honda Engine - Quick start guide on page D is

provided for easy reference. Read and understand

Honda Owner's Manual for further detail.

Parts Identification | C