- ページ 8

洗濯機 Dultmeier Sales DUFB_A-DのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Dultmeier Sales DUFB_A-D 12 ページ。 Air pump foam brush system - demand

Testing & Operation

1. With the chemical tank 2/3 full, turn on the air

compressor.

Make certain that your compressor

IMPORTANT

comes up to final pressure.

2. The Foam Brush System is factory tested and

set. The gauges should read Approx. 30 PSI for

Chemical (Fig. 7-A) and 20 PSI for Air (Fig 7-B).

These settings are a good starting point and will

produce a nice, thick foam. Further adjustment

may be required depending on your preferences.

Air pressure must be lower

IMPORTANT

than pump pressure or air will

override the chemical causing

inconsistent spitting foam.

To save time, having an assistant

is recommended for these next steps.

3. Open the ball valve on the foam brush handle.

4. The Foam Brush pump should turn on, start

cycling, and deliver chemical to the brush. This

may take some time depending on the length of

tube/hose to your bay.

5. Check for proper flow and foam consistency.

Repeat this step if you purchased a multi-bay

system.

6. Adjust flow by turning the metering screw on the

chemical solenoids. (Fig. 9)

7. Close the ball valve on the foam brush handle.

Figure 7

Helpful Hint !

Figure 8

Figure 9

Installation & Operating Instructions | 6

Bay Metering

Screw