- ページ 3

製本機 Dumor EASYBINDER 80のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dumor EASYBINDER 80 10 ページ。

ページを印刷する

Operational temp

To 140°C with std chip

To 180°C with special chip

Cover press

(10) see pictures at end of the manual

Variable time.

Variable side pressure via screen.

Variable back pressure via 2 knobs on the front of the machine to suit different cover stock thicknesses.

(10a)

Latent Safety Hazards To Be Aware Of:

Finger pinch points

On the paper clamp (11), end of run of the clamp traverse (12), cover pressing station

(10)

when the machine is processing a book binding

operation.

(13)

Paper chip fan if the waste bag is removed and the machine is started.

Milling head if you open the safety covers by hand.

(14)

Scalding points

on the glue tank and nearby parts when the tank is fully warm.

(15)

Fume hazards

The machine should be run in a large room with access to an fume exhaust port.

(15)

The fumes are not toxic but can cause a headache in a confined space.

Machine installation

(16)

Level the machine using the 4 feet.

Make sure the machine is connected to a earthed power line as it is single insulated.

Remove all the transport clips (Red ) if you try to start the machine with the clips in place you will destroy the motors, no warranty!!!

Make sure there is correct fume ventilation.

Install the guard over the tank area located in the cupboard of the machine for transport.

(17)

Install the front tray for the covers.

(13)

Install the waste bag.

Working principle

(18)

The machine is turned ON.

The glue will gradually melt between 120°C and 140°C using the standard glue other glues may need a higher temperature.

Hint: the melt process can take some time and can be accelerated by covering the tank with a piece of card to reduce heat losses until the

glue rollers start to turn.

When the glue is melted the rollers will begin to turn to stir the glue to get the glue evenly warmed up.

When the glue is fully stirred (ca 5min) the machine can be used.

Place the paper block

The fresh paper is loaded into the paper clamp to the left register and squared up.

Attention to finger trapping:

The clamp is closed by pushing the button.

(11b)

(11a)

There is a finger present safety sensor on the front jaw of the clamp that will inhibit the clamp closing if fingers are present.

Place the cover

(10b)

Place the cover on the cover press into the left side clips

and against the paper tray front stops which have been pre-positioned for the over

length.

(10c)

Place the magnetic buttons to hold the cover in place on the right side of the cover on the moving plates, not the centre plate.