- ページ 3
DCドライブ Danfoss 176F6746のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Danfoss 176F6746 6 ページ。 Cable clamp kit for e3h/e4h drives vlt fc series fc 102, fc 103, fc 202, and fc 302
ページを印刷する
Installation Instructions
Installing the Cable Clamps
Use the following steps to install the cable clamp brackets, 6 large cable clamps, and 1 small cable clamp. Use the large clamps for
mains and motor cables, and the small clamp for control wiring.
1.
Position the 4 holes in the edge of the extension
bracket over the 4 threaded studs on the drive back-
channel.
2.
Fasten 4 M8 hex nuts (T30), securing the extension
bracket to the studs.
3.
Position the 4 holes in the corners of the cable
bracket over the 4 threaded studs on the front of the
extension bracket.
1
M8 hex nut
2
Threaded stud
3
Extension bracket
4
Cable clamp, 16 mm
5
Cable bracket
Illustration 1.2 Cable Clamp Kit Overview
MI35U102
Cable Clamp Kit for E3h/E4h Drives
®
VLT
FC Series FC 102, FC 103, FC 202, and FC 302
4.
5.
6.
6
7
8
9
10
Danfoss A/S © 04/2018 All rights reserved.
Fasten 4 M6 hex nuts (T25), securing the cable
bracket to the studs.
Tilt each cable clamp at a 45º angle and insert the
hooks through any 2 holes in the bracket. Lower to a
horizontal position.
Insert a cable into each clamp and tighten the cable
adjustment screw to secure the cable.
Clamp adjustment screw
Cable clamp, 60 mm
Threaded stud
M6 hex nut
Key hole
3