- ページ 2

DCドライブ Danfoss E3hのPDF インストレーション・インストラクションをオンラインで閲覧またはダウンロードできます。Danfoss E3h 4 ページ。 Top fan replacement

Installation Instructions

Removing the Top Fan

To remove and replace the top fan, use the following procedures. Refer to Illustration 1.1.

Remove 2 screws (T25) from the fan housing.

Slide the fan housing and fans out from under the retaining clips.

Unplug the in-line connector attaching the fan cable.

Feed the cable through the cable access hole.

Lift the fans from the pins in the fan housing.

Installing the Top Fan

Place the fans over the pins in the fan housing. Check that the air direction arrows point upward and away from the drive.

Feed the fan cables through the cable access hole on the top plate.

Reconnect the in-line cable connector.

Slide the fan housing and fans into position under the retaining clips.

Secure 2 screws (T25) in the fan housing.

Fan housing

Mounting pin (inside housing)

Fan

Illustration 1.1 Top Fan

Top Fan Replacement for E3h/E4h Drives

Screw (T25)

Cable access hole

Retaining clip

MI35N102