- ページ 2

DJ機材 Aolait AL230BのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Aolait AL230B 9 ページ。 5r/7r beam moving head

Preface

Anyone undertake the installation, operation and maintenance of light fixture, should be required:

-------professional qualification & experience

-------Operating strictly under the instruction of this manual

-------Keeping the manual until never use

-------Making full notes in the manual after repair or fix.

When unpacking and before disposing of the carton, check there is no transportation damage before

using the projector. Should there be any damage caused by transportation, consult your dealer and

do not use the apparatus.

Security Indications

Every unit is tested completely before leaving the factory, and in good condition to performance. In

order to keep the light in best situation and safety using, please read carefully and comply with the

Safe usage instruction & notice of this manual.

Very important: non-compliance the safe indication of this manual, may cause personal injuries &

property damage. This loss is excluded in the range of quality assurance.

If the light fixture has suffered fierce expand with heat and contract with cold (For example, under

insolate during transportation), do not turn on the current immediately, because the water arising

therefrom will damage the light. Please turn on light until it recover the ambient temperature.

This light belongs to First-grade protective product. It must be suited with the First-grade protective

safe jack. Lighting fixture must be grounded reliably.

Do not connect this light with Dimmer.

Before turn on light, please check and make sure: the power supply should not be higher than the

power which marks on the bottom panel; light power switch should be off; and the power cord good

in shape.

Do not let power cord touch other cord directly, and be careful when operate power cord & all joints

etc! Only can hold its joints when move power cord. Hold joints then draw carefully from jack when

cutting power, and do not draw cord directly.

Light fixture may cause some fog or smell when turn on power first. It is normal rather than bad

quality.

When the light running, its housing will be heated and the part of light temperature is high, that is a

normal condition which should not touch it by hand to prevent injured.

Please choose the same type bulb & protective tube when they needed to replace.

Please turn off the light then removal power cord joints when light fixture is nonuse or required

maintenance.