- ページ 2

楽器アクセサリー Duncan SLS-1のPDF 配線図をオンラインで閲覧またはダウンロードできます。Duncan SLS-1 2 ページ。 Pickup lipstick tube for strat

Wiring Diagram for

Pickup Models:

SLD-1 Lipstick Tube for Danelectro

5427 hollister avenue, santa barbara, ca 93111

tel 805.964.9610 fax 805.964.9749

www.seymourduncan.com

We're not just pickups anymore. Seymour Duncan also makes super cool stomp boxes.

And our sister company, D-TAR, is turning out some really hip amplification products for the

Congratulations on your purchase of a fine, hand-built, Seymour Duncan electric guitar pickup! Installing

this pickup in your guitar isn't rocket science. And, if you're already handy with tools, it'll be a snap for

you–and fun too! But if you have no experience handling red-hot soldering irons, you'd be well advised

to take your new pickup and your trusty guitar to a qualified guitar tech.

The basic steps include:

1. Remove the strings from your guitar.

2. Remove the control panel cover-plate from the back of the guitar.

3. De-solder the original pickup's wires from the controls and make sure to

remember where they were connected.

4. Unscrew the original pickup from the back of the guitar and remove it from

the guitar.

5. Put the Seymour Duncan pickup into the guitar and install the mounting screws

through the back of the guitar.

6. Tin the wires from your Seymour Duncan pickup, and then solder them into place

where the original pickup's wires were connected.

7. Replace the control panel cover-plate.

8. Restring your guitar and adjust the pickup height so that your new pickup

balances with the other pickup in the guitar. The bridge pickup should be

between 1/8" and 1/16" from the strings when they are pressed down at the

highest fret on the neck. The neck pickup should be set to achieve the best

balance with the bridge pickup.

serious acoustic guitarist (d-tar.com).

Visit seymourduncan.com for additional wiring diagrams.

P/N 501025-110 Rev. B