- ページ 6

DCドライブ Danfoss VLT AutomationDrive FC 301のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Danfoss VLT AutomationDrive FC 301 16 ページ。 24 v dc supply
Danfoss VLT AutomationDrive FC 301 にも：インストレーション・マニュアル (20 ページ), 取付説明書 (6 ページ), インストレーション・マニュアル (18 ページ), 取付説明書 (8 ページ), インストレーション・マニュアル (6 ページ), インストレーション・マニュアル (16 ページ), インストレーション・マニュアル (8 ページ), 取付説明書 (6 ページ)

Installation Guide | VLT® Programmable I/O MCB 115

2 Safety

The following symbols are used in this manual:

Indicates a hazardous situation which, if not avoided, will result in death or serious injury.

Indicates a hazardous situation which, if not avoided, could result in death or serious injury.

Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.

Indicates information considered important, but not hazard-related (for example messages relating to property damage).

The products must only be assembled, installed, programmed, commissioned, maintained, and decommissioned by persons with

proven skills. Persons with proven skills:

•

Are qualified electrical engineers, or persons who have received training from qualified electrical engineers and are suitably

experienced to operate devices, systems, plant, and machinery in accordance with the general standards and guidelines for safety

technology.

•

Are familiar with the basic regulations concerning health and safety/accident prevention.

•

Have read and understood the safety guidelines given in this manual and also the instructions given in the operating guide of the

drive.

•

Have good knowledge of the generic and specialist standards applicable to the specific application.

D A N G E R

W A R N I N G

C A U T I O N

N O T I C E

AN295938195323en-000101 / 130R0655

Safety