- ページ 7

DCドライブ Danfoss VLT FC SeriesのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Danfoss VLT FC Series 8 ページ。 Igbt module replacement for d1h–d8h drives
Danfoss VLT FC Series にも：インストレーション・マニュアル (12 ページ), 取付説明書 (6 ページ), 取付説明書 (6 ページ), 取扱説明書 (11 ページ), インストレーション・マニュアル (6 ページ)

ページを印刷する

Installation Guide | VLT® Wireless Communication Panel LCP 103

Procedure

1. Open the app and establish the Wi-Fi connection, see

2. When prompted, change the default password due to security restrictions. The password must be at least 8 and maximum 48

characters.

3. Replug the VLT® Wireless Communication Panel LCP 103 for the password to take effect. Failing to do so, allows the LCP 103 to

keep broadcasting.

4. Disconnect the app, navigate to smart device settings, and forget the network.

5. Search for the wireless network and connect with the new password.

If the password is not changed, it leaves only 10 minutes for connecting and performing drive operations. After this, the

wireless connection closes.

If the wireless SSID and password are forgotten, reset the password by accessing parameter group 30-9* Wifi LCP via MCT 10 Set-up

Software or LCP 102.

2.3 LED Pattern

Table 1: Descriptions, LED Indicators

LED

Pattern

Solid green

Wi-Fi

Flashing white

Solid white

Alarm

Flashing red

Warn

Solid yellow

Flashing orange

MS, NS1, NS2

(1)

Flashing, then solid orange

MS=module status, NS1=network status, NS2=network status 2.

2.4 Safe Control

The safe control parameter allows the drive to decide the motor behavior if the smart device, for example a tablet, communication is

lost. If the limits are set to [1] Stop motor, the motor stops. If the limits are set to [0] Do nothing, the motor continues to run. This is only

applicable when the motor is in Run state and if the motor has been started from the app.

The communication happens between the MyDrive® Connect App and the VLT® Wireless Communication LCP 103.

Parameter

Parameter 30-97 Wifi Timeout Action

table 1

for descriptions of the white Wi-Fi LED.

N O T I C E

Description

The drive is powered on (normal operation).

Connection pairing successful.

The smart device is connected and communication is OK.

An alarm has occurred.

A warning has occurred.

Identification of the drive when initiated through a winking command

Incompatible drive (LED flashes 3 times and then remains on).

Limits/options

[0] Do nothing

[1] Stop motor

AN331428064824en-000101 / 130R0814 | 7

Installation