- ページ 10

メディアプレーヤー DUNE HD SOLO LITEのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。DUNE HD SOLO LITE 16 ページ。 Uhd 4k and hevc enabled iptv/vod/ott media player

Dune HD solo LITE

Getting Started

Ensure the RC has batteries installed. Connect the player to your TV and to other A/V equipment in an

appropriate way. Use HDMI connection to get the best possible quality of video and audio. Make sure to

switch off the player and all relevant A/V equipment before connecting them. Ensure your TV and other A/V

equipment are configured to use proper inputs. Connect the power cable to the player and switch the player

on using the power switch on the back panel of the player.

The player will perform its initial loading procedure, which may take up to about 1 minute. During the loading

procedure, "DUNE HD" logo is shown on the TV screen.

If you do not see "DUNE HD" logo on the TV screen when you switch on the player, it may mean

some problem with the connection between the player and the TV or that a wrong video input is

chosen in the TV or A/V receiver/switch. In this case, recheck the cables and the settings of the TV or

A/V receiver/switch, or try to use different cables or a different way of connecting the player to the

TV.

If you see "DUNE HD" logo on the TV screen when you switch on the player, but then the picture

disappears and the other picture does not appears during at least 10 seconds, it may mean that a

wrong video output mode is configured in the player. In this case, press the "REC" RC button, and

then press one of the RC buttons "1", "2", "3", "4" or "5" to switch to a different video output mode

(see "Quick Setting of Video Output Mode" for more information).

Finally, you should see the initial setup wizard, which will allow you to perform the initial player configuration.

After that you should see the main screen of the player menu. The main screen shows menu items which

allow the use of different player functions and access to all storage devices and network drives connected to

the player.

Adjust the player settings as needed using "Setup" menu.

Quick Setting of Video Output Mode

The "REC" RC button allows quick setting of video output mode without entering the player setup menu.

This way of video output configuration may be required if you see no picture on the screen after connecting

your player to a TV.

Press the "REC" RC button and then one of the RC buttons "1", "2", "3", "4", or "5" to switch to one of the

following video output modes respectively:

1. Composite PAL

2. Composite NTSC

3. HDMI, 480i, 60 Hz

4. HDMI, 720p, 60 Hz

5. HDMI, 1080i, 60 Hz